MICROBOT MOTOR DRIVER
| Uploader: | Faegul |
| Date Added: | 1 May 2011 |
| File Size: | 54.57 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 21828 |
| Price: | Free* [*Free Regsitration Required] |
Add to shopping cart.
DC Dual Motor Driver 30V 4A V2
The maximum supply voltage supported by this board is 30V. Add to project More from Microbot. The Dual DC Motor Shield is a shield that has been projected to enable an Arduino board to drive two brushed DC motors or one 4-wire two-phase stepper motor, controlling the speed and direction of each one independently.
Specifications Supply voltage 7 - 30V Supply current logic 24mA typ. The logic of the Dual DC Motor Shield is powered directly from the Arduino board, whereas motor outputs can be powered both from Arduino Vin pin or from external power source, even if it is strongly encouraged to use external power supply.
By using our services, you agree to our use of cookies. We will send you a mail when the product becomes available again Error during request registration Not available. To enable or disable each channel independently of the input signals there are provided two enable inputs E1, E2 positioned on the front of the board; motor velocity regulation is obtained applying to these pins a PWM signal with a 20KHz max. For the I2C communication, there are two different slave addresses selectable through a jumper, and in this way it is possible to use two Easy Motor Controllers on the same serial line, and then control them by using a single external controller.
All orders after this time will be shipped again from Supply voltage for motors 46Vmax.
Microbot | Active Robots
The sensor is the integrated circuit TCN75A and you can refer to its datasheet to better microboy its communication protocol. This shield is based on the L, a high voltage, high current dual full-bridge driver.
By using our services, you agree to our use of cookies.
Maggiori informazioni Read more. To ensure safely operating condition you mohor measure the motor current absorption of each motor; this allow to avoid stall conditions. The maximum supply voltage supported by this board is 46V. The maximum supply voltage supported by this board is 46V To ensure safely operating condition you can measure the motor current absorption of each motor; this allow to avoid stall conditions.
DC Dual Motor Driver 30V 4A V2
It has direction leds for help testing operations. The minimum supply voltage allowed is 7V, so you can use also two-cell LiPo batteries 7. Microbot Easy Motor Controller Microbot.
To optimize the response to RC commands you also have the calibration function on the receiver signals.
Moving the jumper from one side to the other the power source can be changed. On this shield it has been included an integrated I2C digital microboy sensor to monitor the shield temperature in order to prevent overtemperature threat.
The possibility of using two limit microswitches that will act as a protection, interrupting the movement of the motor in the two possible directions when the pressure of the microswitch is detected, completes the functions on the board.
We would like to ask you to consider this in ,otor order planning!
This product is currently not available. The Easy Motor Controller allows to control the speed and the direction of rotation of a DC motor through three different possible inputs: It is a mitor voltage, high current dual fullbridge driver designed to accept standard TTL logic levels and drive inductive loads such as relays,solenoids, DC and stepping motors.
This powerfull DC motor driver can drive motor up to 30V and 4Amax. Microbot Easy Motor Controller.
Microbot Easy Motor Controller
We will send you a mail when the product becomes available again Error during request registration Not available. In fact when the L chip works at high current values it may become very hot and this heat can flow through all the shield.
Cookies help us deliver our services.
Comments
Post a Comment